Getting started with Conserv
Hooray! You’ve received your equipment from Conserv. Here is everything you need to get started:
⚠️ IMPORTANT NOTE: Do not pull the tabs on yous sensors until the gateway is connected and online.
Step 1
A. Attach Antenna to Gateway
B. Plug in Network Cable (optional)
C. Plug in Power Adaptor
Step 2
D. Pull Plastic Tab from Sensor Battery. You must do this within range of the gateway.
E. Update the firmware on the sensor: Instructions
F. Install Sensor on wall with command strips*
*We recommend installing Conserv’s sensors with the supplied Command Strips as this is most secure.
Step 3
G. Log into your account at App.Conserv.io. Within minutes, you’ll start seeing environmental readings.
Do you have a Cold Storage Sensor, Outdoor Sensor, or Leak Detector?
Setup for these is a little different from the standard Smart Collection Sensor. Check out these resources:
Additional resources
Hardware:
- Setting up your new Conserv Monitoring System
- Adding new sensors to existing Conserv Monitoring System
- How to use the Command Strips to install the sensors
- Where should I put my sensors?
- How to use my equipment to test range?
- Update the firmware on new sensors
- Sensors did not come online? Read this!
- Swapping old sensors for new? Read this!